null

Matala Rocking Piston Compressor Rebuild Kits

Matala

3 reviews Write a Review
SKU:
ASYAS001
$57.00
$57.00

Description

Matala Rebuild Kits for Rocking Piston Compressors.

These rebuild kits are easy to replace.

There are 3 sizes available. 

Rebuild Kit for for MPC-60
  • include no.8 Piston Cup x 1, no.11 Cylinder x 1, no.15 Upper/Down Valve Flapper x 2, no.12 Cylinder O-ring x 1, no.17 Valve O-ring x 1)

Rebuild Kit for for MPC-120

  • include no.8 Piston Cup x 2, no.11 Cylinder x 2, no.15 Upper/Down Valve Flapper x 4, no.12 Cylinder O-ring x 2, no.17 Valve O-ring x 2)

Rebuild Kit for for MPC-200

  • include no.8 Piston Cup x 2, no11. Cylinder x 2, no.15 Upper/Down Valve Flapper x 4, no.12 Cylinder O-ring x 2, no.17 Valve O-ring x 2)

Typically the pump rebuild kits needs a rebuild kit every 12 months to 18 months. It is relatively easy to replace.  The rebuild parts are considered a “wear and tear” item and not covered under the warranty.

  • If the motor still hums but no air flow then it can be rebuilt.
  • Sometimes the piston will stick and again a rebuild kit can fix it.
  1. plug it in and tell us if it makes any noise or hums.
  2. If hums but does not turn over then the top head can be removed with 4 Allen screws and the inside top of piston can be seen.  If the pistons can be pushed up and down by hand or finger and it gives a hum or tries to start then again it needs a rebuild kit.

Here is a link to YouTube video:

https://www.youtube.com/watch?v=8btZoHbqB5k

Videos

Extra Information

Brand:
Matala
PDF:
rocking-piston-instruction-manual.pdf

Warranty Information

http://www.underwaterwarehouse.com/Matala-Rocking-Piston-Compressors/Matala-Rocking-Piston-Compressor-Rebuild-Kits-p-4646.html

    3 Reviews

  • Posted by Riz on Dec 16th 2021

    5

    rebuild Matala

    easy kit

  • Posted by Michael Ernst on Dec 14th 2021

    5

    rebuild kit

    Easy to use, repair lasts pretty long.

  • Posted by Fred on Oct 31st 2021

    4

    Matala MPC 120 Rocking Piston Rebuild Kit

    Kit worked as anticipated. Instructions are week, take pictures as you disassemble. First re-build on this unit, note the factory torqued the cylinder head bolts so tight I had to use large vice grips on the hex head to break all 8 free. Also appears that the cylinder o-rings were glued into the receiving slot, so it took a couple of hours to dig them out w/o scratching the metal. Kit good, albeit expensive for what you get, compressor frustrating, but will be much easier from now on to do re-builds.